Joined: 21 Jan 2018
Posts: 38
Location: Colorado
|
|
I joined the 16 ga low pressure group and have gone through the various recipes for low pressure (sub 6000) loads for the 2 1/2 Cheddite hulls identifying 3 good possibilities. Before ordering the components I dont already have, Id be interested in any recommendations from the group. I have a MEC 600 Jr with short kit and 6 pt crimp. 3/4, 7/8, or 1 oz loads would all be fine. I have other higher pressure loads that I use in my 2 9/16 fluid steel barreled guns but am searching for a couple of lower pressure loads for an older twist steel barreled sxs that has already passed its inspection and barrel wall thickness measuring. Thanks. |
|
|
|