Author |
Message |
< 16ga. Guns ~ Darne Halifax - yes, no, maybe |
|
Posted:
Sat Nov 27, 2021 9:01 am
|
|
|
Joined: 13 Oct 2014
Posts: 253
Location: North Shore of Boston
|
|
A while back I asked about Darne shotguns in general , and received a wealth of of information in return for I am thankful.
What I recall is that no one mentioned anything specific about the Halifax - other than they had one, and by the way he talked it sounded to be a reliable shotgun.
Well I've got my eye on a Halifax - is there anything that I should be aware of ? |
_________________ Bill K
North of Boston
Browning New A5 Sweet Sixteen circa 2019
Browning Citori Upland 16 GA circa 2014
Darne R10 1962
Browning Sweet Sixteen 16 GA circa 1957
Savage Fox Sterlingworth 16 GA circa 1934 |
|
|
|
|
|
|
Posted:
Sat Nov 27, 2021 3:19 pm
|
|
|
Joined: 19 Jun 2004
Posts: 1480
Location: Mpls, MN.
|
|
Pitted bores, mostly. Also, short chambers and, usually tight chokes. The Halifax was a product of poor economic times, and the worse things were, economically, the more grades of Halifax there were. Two grades in the 1930s.
A Halifax has brazed barrels, instead of monobloc silver soldered tubes. Be advised you cannot bend the stock on any Darne, Halifax included, due to the way it is attached to the gun. You will break the stock if you attempt this. You can alter LOP with a pad, but, that is about it. Try to find one that fits to begin with. The safety is something guys struggle with, try to figure out how to make it work for you, maybe before you buy it.
I’ve used a few different Darnes for 35 years or so, they are some of my favorites. Post photos of what you are looking at, and I’ll tell you what I can about it.
Best,
Ted |
_________________ "Well sir, stupidity isn't technically against the law, and on that note, I'll remove the handcuffs and you are free to go". |
|
|
|
|
|
|
Posted:
Wed Dec 29, 2021 10:02 am
|
|
|
Joined: 23 Feb 2008
Posts: 191
Location: Nebraska (It’s not for everyone)
|
|
I had a Darne R13 that fit me and I shot it well but could never get used to the safety. I don’t know how many pheasants that I never got a shot at because of the safety. Same with a Manufrance Ideal only that gun didn’t fit and I couldn’t hit anything with it. That safety was bizarre and I never hunted with that one. They are both unique and cool but they went down the road to someone else. |
_________________ Mediocrity knows nothing higher than itself, but talent instantly recognizes genius.
- Sir Arthur Conan Doyle |
|
|
|
|
|
|
Posted:
Wed Dec 29, 2021 6:53 pm
|
|
|
Joined: 19 Jun 2004
Posts: 1480
Location: Mpls, MN.
|
|
You can (usually) switch the safety on an R model around in the breech block, moving it to the other side. If that doesn’t work, the opening lever itself can double as a safety, just leave it up, under spring tension, against your thumb. It is fairly easy to keep it in that position, with the breech not actually in contact with the ends of the barrels.
I was left handed, so, the safety stuff, either model R or V, mostly went over my head.
Best,
Ted |
_________________ "Well sir, stupidity isn't technically against the law, and on that note, I'll remove the handcuffs and you are free to go". |
|
|
|
|
|
|
|
All times are GMT - 7 Hours |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|