Author |
Message |
< 16ga. Guns ~ Citori White Lightning failure to fire |
|
Posted:
Mon Nov 02, 2015 8:15 pm
|
|
|
Member
Joined: 24 Jun 2008
Posts: 70
Location: blackfoot,id
|
|
Having FF issues on my Citori - have had previous problems on RGL's on the top barrell which I cured by not using RGL's but now having FF on both barrells using RIO ammo. Suggestions? |
_________________ brdhunter |
|
|
|
|
|
|
Posted:
Mon Nov 02, 2015 8:43 pm
|
|
|
Member
Joined: 15 Apr 2007
Posts: 9464
Location: Amarillo, Texas
|
|
|
|
|
|
|
Posted:
Mon Nov 02, 2015 10:49 pm
|
|
|
Joined: 15 Jun 2010
Posts: 1358
Location: Twin Cities, MN
|
|
If the interior of a Citori gets dirty it can clog up the firing pins and slow them down and/or decrease their protrusion. Pull the stock and remove the firing pins and their springs and make sure everything's clean. If that doesn't work then bringing it to a gunsmith who can measure firing pin protrusion is in order.
Good luck,
Jeff |
|
|
|
|
|
|
|
Posted:
Wed Nov 04, 2015 1:03 am
|
|
|
Member
Joined: 31 Dec 2008
Posts: 404
Location: Westport Wa
|
|
Wife's had that on a box of lead I had reloaded for trap. Only the lower barrel was misfiring. Checked the rims and they were thinner than others that fired reliably. It appears I sized them a bit much... There are a few threads about 'only the lower barrel' misfiring on here. |
|
|
|
|
|
|
|
Posted:
Wed Nov 04, 2015 3:46 pm
|
|
|
Member
Joined: 16 Dec 2004
Posts: 203
Location: Southern California
|
|
...Sonia's brand new '20 Citori White Lightning had same problem.
Took it to Bob Day in Pico Rivera. He said this was a somewhat common problem, pulled the stock and dressed some part of the mechanism with a file. Sorry, I don't recall what it was, anyway, seems to be functioning as intended now. |
|
|
|
|
|
|
|
Posted:
Sat Nov 07, 2015 1:54 pm
|
|
|
Member
Joined: 12 Mar 2005
Posts: 6535
Location: massachusetts
|
|
Cleaning out the firing pin ports in a break open gun's breech face w/o removing the stock can be quick and easy. I simply make sure the pins are cocked first. I then use the applicator tube supplied w/ a can of WD40 to squirt in a very conservative amount into the ports, followed up with a gentle probing with a piece of suitably sized soft steel or brass wire to loosen and push out any accumulated junk if the gun design allows it. Easy does it is the way. We ain't trying to pressure wash the breech out w/ lube or drill for oil with the wire here. |
|
|
|
|
|
|
|