Author |
Message |
< 16ga. Ammunition & Reloading ~ Loading 2inch 12 ga |
|
Posted:
Fri Sep 20, 2019 6:13 pm
|
|
|
Joined: 20 Oct 2015
Posts: 77
|
|
Need some help reloading some 2 inch 12 ga loads if anyone has any favorite 3/4 oz or7/8 oz loads would love to hear about them. Been loading 2.5 in 16 ga loads from low pressure group for a while. Could these loads be used in the short 12, if they fit. Going to roll crimp.
Thanks for comments |
|
|
|
|
|
|
|
Posted:
Fri Sep 20, 2019 7:00 pm
|
|
|
Member
Joined: 15 Apr 2007
Posts: 9463
Location: Amarillo, Texas
|
|
http://www.hodgdonreloading.com/data/shotgun
Two different offerings
Example
Manufacturer Powder Primer Wad Grs. Pressure Vel. (ft/s)
Hodgdon Internat'l Win. 209 BP Compact Euro. 16.0 8,400 PSI 1,180
Mike |
Last edited by skeettx on Sat Sep 21, 2019 12:12 pm; edited 1 time in total |
|
|
|
|
|
|
Posted:
Sat Sep 21, 2019 11:32 am
|
|
|
Joined: 20 Oct 2015
Posts: 77
|
|
Thanks Mike
Got the powder. Wads,over shot card, and 12 ga roll crimper on way from precision reloading. |
|
|
|
|
|
|
|
Posted:
Sat Sep 21, 2019 12:11 pm
|
|
|
Member
Joined: 15 Apr 2007
Posts: 9463
Location: Amarillo, Texas
|
|
Good luck, let us know if you incur any difficulties.
I have a BUNCH of Lyalvale 2" ammo that I was going to shoot
in my light 2 1/2" chambered French doubles, BUT the ammo kicks
so hard I get a headache and bloody fingers, so I load light 2 1/2
ammo for them.
What will you be using the ammo for?
Mike |
_________________
,
USAF RET 1971-95 |
|
|
|
|
|
|
Posted:
Sun Sep 22, 2019 8:00 am
|
|
|
Joined: 28 Mar 2008
Posts: 1460
Location: Eagle, Nebraska
|
|
Not sure about 2" but I have loaded 2 1/2" in 12ga.
I will have to dig around in my files for what I used.
At first I used hard wads, then I think I switched to short brush wads?
And I know the last time out I used gas seal from BPI and spred-r X insert. I cannot remember, but I think those were 1oz loads, around 1300fps,
Used them for quail. Don't remember the powder either, I know it was stuff I didn't have on hand and had to go purchase.
Earlier loads I think I used Bullswye? Started out using the BPI data.
But those brush loads, don't think I used bullseye, maybe it was PB? As I was experimenting with PB and had some on hand.
I will dig around, see if I can find the data, instead of rambling on about what I might of used... |
|
|
|
|
|
|
|