Author |
Message |
< 16ga. Guns ~ French Charlin shotgun |
|
Posted:
Tue Aug 16, 2022 10:27 am
|
|
|
Joined: 13 Oct 2014
Posts: 253
Location: North Shore of Boston
|
|
I’ve come across a French Charlin SXS - similar to a Darne sliding Breech shotgun.
I’d appreciate anyone’s thoughts |
_________________ Bill K
North of Boston
Browning New A5 Sweet Sixteen circa 2019
Browning Citori Upland 16 GA circa 2014
Darne R10 1962
Browning Sweet Sixteen 16 GA circa 1957
Savage Fox Sterlingworth 16 GA circa 1934 |
|
|
|
|
|
|
Posted:
Tue Aug 16, 2022 12:42 pm
|
|
|
Joined: 17 Jul 2008
Posts: 765
Location: Great State of Kansas
|
|
i Bought a 16 bore Charlin in a pawnshop in Ukiah, California... I liked it it felt good between the hands and appeared to be well built. I shot it for years, taking lots of eathered critters and even a feral hog with it
I never knew amuch about it didnt need to JUst shot it....Damn good gun! My daughter has it now... |
|
|
|
|
|
|
|
Posted:
Fri Aug 19, 2022 6:16 pm
|
|
|
Joined: 19 Jun 2004
Posts: 1480
Location: Mpls, MN.
|
|
Safety lever can be hard to move- it has a stout little leaf spring on it. A Darne and a Charlin are much different designs. The Darne is toggle, cam, and vertical bite locked, a Charlin is an over-the-center device. Sounds weird, but, there is no mechanical lock holding a Charlin closed, just a mechanical advantage over the breech. when the lever is closed.
They are both good guns. I’ve owned both, would own the right, good fitting example of either, again.
Best,
Ted |
Last edited by Ted Schefelbein on Sun Aug 21, 2022 6:38 pm; edited 1 time in total _________________ "Well sir, stupidity isn't technically against the law, and on that note, I'll remove the handcuffs and you are free to go". |
|
|
|
|
|
|
Posted:
Sun Aug 21, 2022 4:57 pm
|
|
|
Joined: 17 Jan 2014
Posts: 1377
Location: Denver, Colorado
|
|
I did not realize that the two designs were so different. There's always something new to be leaned here. |
_________________ 'Tis better to burn out than it is to rust...... |
|
|
|
|
|
|
Posted:
Mon Aug 22, 2022 9:25 pm
|
|
|
Member
Joined: 17 Feb 2007
Posts: 497
|
|
Great shotguns, I have found them to be smoother than Darne, but as mentioned above not as strong as a Darne, but plenty strong for shotshells.
I believe they were made in grades two through eight.
The grades being designated by the number of animals such as rabbits, birds, tigers, and stars stamped on them.
The safety is a little odd, and takes getting familiar with.
Mine is a six rabbit version in a 12 gauge.
Most of the Charlins will be stamped 65mm for chamber length. |
|
|
|
|
|
|
|
Posted:
Tue Aug 23, 2022 8:32 pm
|
|
|
Joined: 19 Jun 2004
Posts: 1480
Location: Mpls, MN.
|
|
There were several owners of the Charlin company over the near 100 years of operation. There are several different versions of grade stamps used.
I have no evidence a Charlin is stronger, or weaker than a Darne. Or, vice versa. They are two different means to an end. They both work well. There are more differences in the people who use, and love or hate them, than in the guns.
The smoother thing only matters when the gun is cocked, and you are cycling the action without cocking the gun. Both designs take about the same effort to cock the action. This is comparing an R Darne to a Charlin. A V Darne is cocked in the first quarter inch or so of opening, and is a different kettle of fish.
Best,
Ted |
_________________ "Well sir, stupidity isn't technically against the law, and on that note, I'll remove the handcuffs and you are free to go". |
|
|
|
|
|
|
Posted:
Wed Aug 24, 2022 1:17 pm
|
|
|
Joined: 27 Nov 2020
Posts: 84
Location: mtns of central PA
|
|
I’ve been lusting over a 16 gauge Charlin on GB… |
|
|
|
|
|
|
|