Author |
Message |
< 16ga. General Discussion ~ Oops! |
|
Posted:
Fri Oct 07, 2022 6:41 pm
|
|
|
Joined: 27 Aug 2020
Posts: 93
Location: SE TX Marsh and Young County Tx
|
|
Great job! Glad you got it back into fighting shape! |
|
|
|
|
|
|
|
Posted:
Sat Oct 08, 2022 7:45 am
|
|
|
Joined: 09 Aug 2007
Posts: 444
Location: WI
|
|
The No 10 pin is 0.623" on the small end, 0.706" on the large end, and 4" long. That gives it a taper of about 0.020" per inch.
I considered trimming the large end back to where it matched the bore diameter and pushing it though from the breech, but it worked fine the other way.
|
|
|
|
|
|
|
|